The original part is an isolated, switched-mode converter; high efficiency. The LM317 is a non-isolated, linear regulator, and not suitable for 48V input. (A linear regulator with 48V input & 15V output to a 2W load would be dissipating almost 4W of heat; it would need quite a large heatsink adding, making it overall far larger than the original device, as well as wasting a lot of energy ...
I have put back together the entire gimbal already, and I would much rather superglue a plastic piece to the motor than fully disassembling the gimbal again and replacing the motor entirely. I am also looking for replacement Philips 1 screws for the gimbal internals. does anyone have the specs on the screws?
Repair Service: Replacing the LR arm axis was honestly a relatively easy repair. After replacing the arm, and powering up the gimbal does its vertical and horizontal tests, but the roll motor "snaps" to ~-45* offset and doesn't move. The roll motor "buzzes" lightly and stays engaged, providing resistance to the touch.
You can try replacing it. I'd use a 2A standard diode. The leads and body look too fat for a simple 1N4001 to 1N4007 range. Also, are you sure it's the problem? Is this the switch by the driver's left knee? To toggle the dome light from always-on to off to on-when-door is open? Or the door switch.
I was swapping motherboards between two of my Mini 3 Pros, and noticed that one of the 4x arm antenna connectors was damaged and would not reattach to the new motherboard. I cut it off thinking I could re-solder an undamaged connector on it, but the wire was far too intricate and delicate to be...
When replacing props, do you replace all 4 or just the damaged one? Do DJI props come as a matched set of 4? Other than DJI what's the best source for props. Bill
Just by replacing vision sensors It will not work . Professional calibration by specific tool is required . Contact any drone repair or service in your area I just wait, official calibration software support to change it. Like it is done in Mini 3 Pro.. We will see..
Hello. I need to replace both rear motors. I don't want to disassembly whole drone, so I'm thinking about pulling out the motor from the arm, cut the wires and solder new motor. I know this is possible, because I pulled my motor out, but I'm worried about antenna and it's signal wire, because...
