Never one to pass up the recycle pile at work, [Scott] usually doesn’t find much. A few old hard drives, maybe a ancient laptop every once in a while, but on very rare occasions he finds something ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...

Designed for medical devices, scientific and optical instruments, embedded automation applications, and other small-footprint devices needing dual-axis motion control, this system is designed to work ...

This Design Idea further develops a previous one integrating a stepper-motor driver in a CPLD (Reference 1). However, this idea integrates not only the driver, but also a simple one-axis stepper-motor ...

Seeing this Toshiba motor drive, my first thought was ‘what a neat chip for pairing with an Arduino’ as it combines operation across 1.8 to 7V with up to 4A drive – so that is Li-ion batteries, 5V USB ...

Oriental Motor is pleased to announce the arrival of the EtherNet/IP communication protocol to the αSTEP AZ Series AC Input stepper motor drivers. This new EtherNet ...