Jul 2, 2022 · Hi TFP! New pool owner here, and working on learning the ropes. I have my chemicals and testing down, now I am fine tuning my set up. I have around 11,000 gallons and just had the Pentair IntelliFlo Variable Speed High-Performance Pool Pump installed. What would the best settings be to have my...

Mar 19, 2018 · Finally replaced my single speed with a Jandy VSP. The install tech suggested that I run at ~2000rpm for 6 hours. His experience was that for summer weather slow speeds for a long time does not filter as well. It kind of defeats the purpose of a VSP in my option. What would be a good be a...

Apr 29, 2024 · On a VSP why would I use RPM instead of GPM? 2) Currently going through pool school (pool is brand new), reading a ton about adding chemicals and setting a higher flow rate or running the pump 24/7 vs less often. Our pool builder set the pump to run 24/7 at 55 GPM on the pool, heater, and cleaner (3 different settings but all set the same).

May 13, 2009 · We have a new pool build with the Intelliflo3 VSF and the outdoor Easytouch Control System. My pool guy asked me to kick up the speed of the pump for the “Quick Clean” cycle (he’s not familiar with Easytouch), but the Pentair Home app has the controlled by automation message. I don’t have a...

Aug 1, 2025 · The VSP motor must see a poll before it can respond. Once you tell the Aqualink RS that a VSP pump is out there (via the VSP setup page), the Aqualink RS begins polling the motor’s address. Century Connect can then see the polling and figure out …

Jun 20, 2015 · I just installed the new Omnilogic Control Panel. When I try to configure the VSP, it does not show up in the list of detected devices. It appears that the OmniLogic panel is unable to "see" it and therefore unable to obtain it's HUA. High …

Aug 21, 2024 · I am looking for assistance on how to wire the IC40 SWG into our Intellicenter. Power center has been mounted and wires run. Filter pump is IntelliFlo VSF and is currently wired directly into the breaker. I just want to make sure the photo (with markups) is the correct way to rewire the VSP to the relay along with the SWG.

Jul 25, 2021 · Still need help getting the VSP to communicate with the HUA (Hayward unique address). With the password I was able to reconfigure my network so my phone app works.

Jan 20, 2018 · Controls pool, spa and gas heater. Ideally, i would like to install a new VS Pump and use as much of my automation system as possible. My concern is that the Hayward VSP only work with Software Rev 2.65 and above. Is there an upgrade to my existing system, or would i have to replace? If no upgrade, should i go with a 2-speed pump replacement ?

Aug 31, 2024 · VSP Derby is now transmitting primarily on 460.375. 453.900 and 460.150 are used infrequently, possibly due to the mobile units location. One Saturday night in early July the dispatcher for ST Johnsbury was handling all of the VSP communications in Orange, Caledonia, Essex and Orleans while...